Environmental Protection; Technical Specifications - Metabo Rbe 15-180 Mode D'emploi

You can download a list of spare parts from
www.metabo.com.

11. Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of dust with
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.

12. Technical Specifications

Explanatory notes regarding the specifications on
page 3.
Subject to change in accordance with technical
progress.
U = Battery pack voltage
B = Sanding belt width
B
B = Sanding belt length
L
D = max. pipe diameter
max.
U = max. angle of contact
max
v * = Belt speed in idle mode
0
P = Rated input power
1
P = Power output
2
m = Weight with smallest battery pack
I = Current at 120 V
120 V
Permitted ambient temperature during operation:
-20 °C (-4°F) to 50 °C (120°F) (limited performance
with temperatures below 0 °C (32°F)). Permitted
ambient temperature for storage: 0 °C to 30 °C
* Energy-rich, high-frequency interference can
cause fluctuations in speed. The fluctuations
disappear, however, as soon as the interference
fades away.
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = Vibration emission value (surface
h
grinding)
K = uncertainty (vibration)
h
Typical A-effective perceived sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed 80
dB(A).
Wear ear protectors!
ENGLISH en
9