Initial Operation - Metabo Rbe 15-180 Mode D'emploi

4. Overview
See page 2
1 Slide switch
2 Handle
3 Adjusting wheel for setting belt speed
4 Electronic signal indicator
5 Additional handle
6 Tensioner arm for replacing the sanding belt
7 Sanding belt
8 Press in the spindle locking button only when
the spindle is stationary!
9 Thread for securing the additional handle
10 Arrow (direction of rotation of drive shaft)
11 Battery pack release button
12 Battery pack *
13 Dust filter*
14 Button of capacity display*
15 Capacity and signal display*
16 Locking button*
*equipment-specific

5. Initial Operation

5.1 For mains powered machines only
Connection to Power Mains
Before commissioning, check that the rated
mains voltage and mains frequency stated on
the type plate match your power supply.
Always install an RCD / GFCI with a maximum
trip current of 30 mA upstream.
5.2 For cordless machines only
Dust filter (p. 3, fig. B)
Always fit the dust filter (13) if the surroundings
are heavily polluted.
The machine heats up faster when the dust
filter (13) is fitted. It is protected by the
electronics system from overheating.
Attaching:
Fit the dust filter (13) as shown.
Removal:
Holding the dust filter (13) at the edges, raise it
slightly and then pull it downwards and remove.
Rotating battery pack
See illustration D on page 3.
The rear section of the machine can be rotated 270°
in 3 stages, thus allowing the machine's shape to be
adapted to the working conditions. Only operate the
machine when it is in an engaged position.
First press the locking button (), rotate the rear part
of the machine while keeping it pressed. Release
the button while rotating the machine. The locking
mechanism must engage with an audible "click".
Battery pack
Charge the battery pack (12) before use.
Recharge the battery pack if performance
diminishes.
Instructions on charging the battery pack can be
found in the operating instructions of the Metabo
charger.
"Li-Power" Li-Ion battery packs have a capacity and
signal indicator (15):
- Press the button (14); the LEDs indicate the
charge level.
- The battery pack is almost empty and must be
recharged if one LED is flashing.
Removing and inserting the battery pack
To remove: Press the battery pack release button
(11) and pull the battery pack (12) downwards and
out.
To insert: Slide the battery pack (12) in until it
engages.
Attaching the additional handle
Always work with the additional handle (5)
attached! Secure the additional handle by
screwing it tightly to the left or right.
6. Use
6.1 On/Off switch, continuous activation
Always hold the machine tightly with both
hands on the handles provided ( (2)) and ( (5)).
It is mandatory to use both hands when operating
the machine. Loss of control can cause personal
injury.
Do not operate on a table or holder.
Switch the machine on first and place it onto
the workpiece only once it has reached the full
speed.
The machine must not be allowed to draw in
additional dust and shavings. When switching
the machine on and off and keep it away from dust
deposits.
After switching off the machine, only place it
down when the motor has come to a standstill.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine using
the handles provided, stand in a safe position and
concentrate.
I
Switching on/continuous operation: Push the
slide switch (1) forward. For continuous
operation, tilt it downwards until it engages.
Switching off: press the rear end of the slide switch
(1) and release it.
6.2 Setting belt speed
The belt speed can be preset via the setting wheel
(3) and is infinitely variable.
ENGLISH en
1
0
7