Uline H-1977 Mode D'emploi

H-1977
DOUBLE ROLLING
CLOTHES RACK
TOOL RECOMMENDED
Rubber Mallet
Base with Upright Arms x 1
1. Place rack on ground and remove extension pipes
from upright arms. (See Figure 1)
2. Unfold upright arms and reinsert extension pipes.
3. Insert two hang bars onto the upright arms.
(See Figure 2)
NOTE: If necessary, extend upright arms past
vertical position to insert hang bar.
NOTE: Use a rubber mallet to insert hang bar if
necessary.
4. Adjust extension pipe to desired height.
NOTE: If needed, attach four clamps to base
with supplied screws and washers. These
clamps can hold extensions when not in use.
(See Figure 2)
PAGE 1 OF 3
1-800-295-5510
uline.com
Two Person Assembly
Recommended
Hang Bar x 2
PARTS
Extension Pipe x 4 (Preassembled in Upright Arms)
Screw x 4
(Attached to Base)
ASSEMBLY
Figure 1
Extension
Pipes
Figure 2
Upright Arms
Para Español, vea página 2.
Pour le français, consulter la page 3.
Clamp x 4 Washer x 4
(Attached to Base)
Upright Arms
Upright Arms
Hang Bar
Extension
Pipes
Base
Extension
Pipes
0924 IH-1977