Uline H-11269 Mode D'emploi

H-11269
WATER JUG RACKS
TOOL NEEDED
Rubber Mallet
(optional)
SHELF PARTS
Frame x 2
Shelf x 2
NOTE: Two-shelf wire shelving units include
two shelves and eight sets of shelf supports.
Figure 1
Figure 2
Figure 3
PAGE 1 OF 6
1-800-295-5510
uline.com
Shelf Support
x 16 Sets
ASSEMBLY
POST ASSEMBLY
1. Connect post tops to post bottoms with a post connector. (See Figure 1)
NOTE: Post tops have a black plastic cap in the top of the post.
SELF-LEVELING FEET
NOTE: If installing casters, do not install self-levelers.
1. Make sure post is positioned as shown. (See Figure 2)
2. Insert self-levelers into open end of post. Use a rubber mallet/hammer or
tap on ground to slide self-leveler into post.
3. Repeat step 2 for all other posts.
TO INSTALL OPTIONAL CASTERS
1. Make sure post is positioned as shown. (See Figure 3)
2. Engage the wheel brakes to keep casters from rolling during assembly. Use
a rubber mallet to tap caster stem into posts. (See Figure 3)
POST PARTS
Post x 4
NOTE: Self-leveling feet are located within
post carton.
Self-Leveling
Foot x 4
1224 IH-11269