Evolur CRUISE RIDER Manuel Du Propriétaire page 6

RIDER ASSEMBLY
1
1. Open the storage latch (figure A) and lift
up the handle of the rider until it stands
erect, clicking into place (figure B).
Next, pull up on the handle to extend it
(figures C and D). Note: each time you
open the rider, ensure that it is
completely latched.
2. Front Wheels: Slide each Front Wheel
onto the mounting post at the front of
the rider until they click into place
(figure E). To remove the Front Wheel,
push the release button as shown in
(figure F).
3. Rear Wheels: Put the Brake Rail into the
left Rear Wheel until it clicks into place
(figure G). Next, slide the left Rear
Wheel into the wheel mount until it
clicks into place (figure H). Next, mount
the right Rear Wheel and slide the Brake
Rail into the right Rear Wheel at the
same time (figure I).
Note:
• Tug on the front and rear wheels to
ensure that they are secure. To remove
the Rear Wheels, release the pin lock as
shown in (figure J).
6
I
www.evolurbaby.com/help
J