Hkoenig toad 6 Manuel D'instructions page 8

Very important
· The refrigerator will have better performance at ambient of 20-25
degree; We suggest the refrigerator be powered off if the ambient
temperature is lower than 10 degree.
· After plugging the appliance, allow the unit to cool down for 2-3
hours before placing beverage into the refrigerator compartment.
· Ventilation is very important for this kind thermoelectric
refrigerator; The inside PCB will be broken easily if the ventilation is
bad; It will also reduce the life of the refrigerator.
· The refrigerator applies automatic defrosting system, so there is
no need to defrost it manually.
Power supply
· The refrigerator must be connected to a properly earthed socket
in line with relevant valid country regulations before operating;
· Check the data label (which is on the side of the refrigerator) for
voltage and frequency corresponds to your local one; If not, don't
plug your cable into the socket;
WARNING: To avoid a hazard due to instability of the appliance,
it must be fixed in accordance with the instruction.
Installation instructions
When install a Heat pipe Refrigerator, ventilation should be
considered seriously, please refer to the following:
· There should be left at least 200 cm³ for ventilation
· The distance between wall and refrigerator side should be at least
20mm
· The bottom should be left at least 50mm for air flowing air passing
through must not be preheated
· Entire cooling system should be considered in the ventilation
· The following four pictures show four installation ways: