Reversing The Door - Hisense Rc44C1Gse Mode D'emploi

Reversing the Door

The side at which the door opens can be
changed from the right side (as supplied) to the
left side, if the installation site requires.
Tools you will need:
l. Wrench (5/16",Smm)
2. Philips Screwdriver
GI
3. Putty knife or thin-blade screwdriver
尸 匡
Before you start lay the refrige「ator on it's back in
order to gain access to the base, you should rest
it on soft foam packaging or similar material to
avoid damaging the cooling pipes at the rear of
the refrigerator.
(!) u pper hinge cover
@)lower hinge
(J)
screw hole cover
• Open the refrigerator door and remove all fittings inside the door.
• Remove the upper hinge cover
• Remove the two screws ® that connect the upper hinge ®
on the right side of the cabinet top.
• Carefully lift the door and place it on a padded surface to prevent scratching.
•
to press the button firmly into the hole.
•
• Remove the bottom feet ® and transfer it to the right side of the cabinet.
• Set the door into its new place making sure the pin enters the bushing at the lower frame section (hole).
• Secure the upper hinge ® previously removed in step 4 on the left side of the unit. Make sure the pin enters the bushing on the
upper frame section (hole).
•
• Replace the upper hinge cover
• Turn the door upright again.
• Open the door and attach all fittings.
@ special flange self-tapping screw
®
special flange self-tapping screw
CD.
CD.
－
二
气
}
\、
- － ＆ .-．
（ j )
飞
侐
／
忍 �
、
飞
@ up per hinge
®
bottom feet
勺