Frigelux TOPCV90A++ Manuel D'utilisation page 22

CAUTION — A damaged power cable should be immediately replaced by the manufacturer
or by a qualified retailer, in order to avoid any risk of electric shock.
CAUTION — Keep the ventilation openings well open and ensure that air can circulate by
keeping enough space between the appliance and walls.
CAUTION — Do not damage the refrigerating circuit.
CAUTION — Do not use electrical appliances inside the compartment, unless they are
tolerated by the manufacturer.
CAUTION — The refrigerating and insulating systems contain inflammable gases. When
the appliance is scrapped, it should be deposited at an accredited collection centre. Do not
expose the appliance to fire.
Refrigerating fluid
The refrigerating circuit in the appliance uses refrigerating isobutane (R600a), which is a
natural gas respectful of the environment but highly inflammable. When transporting or
installing the appliance, ensure that no element of the refrigerating circuit is damaged. The
refrigerating fluid (R600a) is
Caution: Fire risk
If the refrigerating circuit is damaged:
▪ Avoid open flames or any source of heat.
▪ Ensure that the room in which the appliance is installed is well ventilated.
It is dangerous to change the specification of the appliance in any way whatsoever.
Damage to the power cable may cause a short circuit and/or electric shock.
Electrical safety
▪ We decline any liability in case of incidents caused by poor electrical installation.
▪ Do not extend the power cable. Do not use an extension cable, adapter, or multi-way
socket.
▪ Check that the wall socket is not damaged. A wall socket in poor condition may cause
the appliance to overheat and explode.
▪ Check that the wall socket used for the appliance is properly accessible.
▪ Never pull on the power cord.
▪ Ensure that the appliance is always electrically earthed.
▪ If the wall socket is loose, do not connect the cable, as there is a risk of electric shock
or fire.
▪ Do not use the appliance if the interior lighting cover is not installed.
▪ Disconnect the appliance before replacing the light bulb (in case of a LED light,
please refer to the chapter "Change the light bulb").
▪ The appliance operates on a single phase 220~240 V / 50 Hz power supply. The
appliance must be connected to an earthed wall socket, in accordance with
inflammable.
20