Product Description; Dimensions - Fig; Installation; Securing The Control Box - Fig - Somfy Cb 230 Rts Manuel D'installation

CB 230 RTS

2 - PRODUCT DESCRIPTION

2.1 Field of application
2.2 Description of the control box - Fig. 1
No. Description
1 Cover
2 Cover screw
3 Circuit board
4 Terminal block
5

2.3 Dimensions - Fig. 2

2.4 Description of the circuit board - Fig. 3
No. Description
1 POWER indicator
2 SET indicator
3 SET button
4 TIME potentiometer
5 Dipswitches
6 PROG indicator light
7 PROG button
8 Terminal block
9 "Cell active during
opening input" indicator
10 "Cell active during closing
input" indicator
11
input indicator
12 Total control input
indicator
13 Pedestrian control input
indicator
14
15
16
3
Permanently lit
Comments
: First time the unit is switched on,
programming not carried out
: Programming complete
: Programming in progress
cleared
1 - 2 Motor 1 torque
3 - 4 Motor 2 torque
5
6
Operating modes
10 Lock release
11 Orange light warning
12 Cell autotest during closing
: Radio reception
control point
Radio control points memorised/cleared
wiring and accessories
: Fault or photoelectric
obstructed
: Fault or photoelectric
obstructed
edge
: Input activated
: Input activated
the motors
accessories outputs
accessories outputs

3 - INSTALLATION

Check that all national requirements regarding the installation and operation
twisting.
wiring.

3.1 Securing the control box - Fig. 4

-
the motors is 20 m.
- Install the control box at least 40 cm above the ground.
-
[1].
bracket.
Attention: check that the control box is level.
[2]. Drill the bracket.
[3]. Mount the control box.

3.2 Wiring the motors - Fig. 5

last.
[1].
[2].
[3].
[4]. Cable the other capacitor provided with the motors to terminals 8 and 10.
cells
[5].
cells
is included at the start of the motorisation commissioning procedure
[6].
3.3
installed.

3.4 Connecting to the mains power supply - Fig. 7

When the control box is switched on, the POWER
wires in case of detachment.
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
must