Connection Notes - Sick Wi130 Notice D'instructions

5.2 Notes on UL approval
5.3

Connection notes

8020148.1O8D/2025-01-14 | SICK
Subject to change without notice
NOTE
Layout of data cables
Use shielded data cables with twisted-pair wires.
■
Implement proper and complete shielding concept.
■
To avoid interference, e.g., from switching power supplies, motors, clocked drives,
■
and contactors, always use suitable EMC cables and layouts.
Do not lay cables over long distances in parallel with voltage supply cables and
■
motor cables in cable ducts.
The IP enclosure rating for the device is only achieved under the following conditions:
The cables plugged into the connections are screwed tight.
■
If these instructions are not complied with, the IP enclosure rating for the device is not
guaranteed!
The device shall be supplied from an isolating transformer having a secondary overcur‐
rent protective device that complies with UL 248 to be installed in the field rated either:
a) max 5 amps for voltages 0 ~ 20 V (0 ~ 28.3 V peak), or
b) 100 / Vp for voltages of 20 ~ 30 V (28.3 ~ 42.4 V peak).
Alternatively, they can be supplied from a Class 2 power supply.
UL Environmental Rating: Enclosure type 1
– Male connector connection: Pin assignment
– Cable connection: Wire color
Only apply voltage and switch on the voltage supply once all electrical connections have
been established.
NOTICE
Do not connect/remove the electrical connection when the sensor is operating. Switch
off the sensor before every use.
Explanation of the connection terminology used in the following tables:
• BN = brown
•
WH = white
• BU = blue
• BK = black
• Q = digital output
• L+ = supply voltage (U
•
M = ground
DC: 12 ... 24 V DC, see "Technical data", page 62
Table 3: DC
WI130T
1 = BN
2 = WH
3 = BU
)
V
O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130
OPERATING INSTRUCTIONS
+ (L+)
External input
- (M)
en
43