Publicité
Les langues disponibles
Les langues disponibles
Cut Hazard
Use a sturdy glass when dispensing
ice.
Failure to do so can result in cuts.
•
Is the ice dispenser stalling while dispensing "crushed"
ice? Change the ice button from "crushed" to "cubed." If
cubed ice dispenses correctly, depress the button for
"crushed"
ice and begin dispensing
again.
•
Has the dispenser
arm been held in too long? Ice will stop
dispensing when the arm is held in too long. Wait 3 minutes
for dispenser motor to reset before using again.
The water dispenser
will not operate properly
•
Freezer door closed completely? Close the door firmly. If it
does not close completely, see "The doors will not close
completely,"
•
Refrigerator
connected to a water supply and the supply
shutoff
valve
turned
on?
Connect
refrigerator
to water
supply
and
turn
water
shutoff
valve
fully
open.
•
Is the water pressure at least 30 psi (207 kPa)? The water
pressure to the home determines the flow from the dispenser.
See "Water Supply Requirements."
•
Kink in the home water source line? Straighten the water
source line.
•
New installation? Flush and fill the water system.
•
Water filter installed on the refrigerator? The filter may be
clogged or incorrectly installed.
•
Is a reverse osmosis
water filtration
system connected
to
your cold water supply?
See "Water Supply Requirements."
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
•
Glass not being held under the dispenser
long enough?
Hold the glass under the dispenser for 2 to 3 seconds after
releasing the dispenser lever/pad.
•
New installation?
Flush the water system. See "Prepare the
Water System" or "Water and Ice Dispensers."
•
Recently
changed water filter? Flush the water system. See
"Prepare the Water System" or "Water and Ice Dispensers."
The dispenser
water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
•
New installation?
Allow 24 hours after installation for the
water supply to cool completely.
•
Recently dispensed large amount of water? Allow
24 hours for water supply to cool completely.
•
Water not been recently dispensed?
The first glass of water
may not be cool. Discard the first glass of water.
•
Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements."
ACCESSORIES
To order replacement filters, call 1-800-807-6777
and ask for the
part number listed below or contact your authorized Whirlpool
dealer.
Stainless Steel Cleaner and Polish:
Order Part #4396095
Standard Base Filter Cartridge:
Order Part #4396841 (T2RFWG2 and P2RFWG2)
11
Publicité
