Stanley IntelliSensor Pro Manuel D'instructions page 9

All manuals and user guides at all-guides.com
Cautions on Operating
Operating Tips
Conventional Construction
109F Manual (B/E/F)
You should always use caution when
nailing, cutting or drilling in walls, ceilings
and floors that may contain wiring or pipes
near the surface. Shielded, dead or non-
powered wiring will not be detected
as live wires. Always remember that studs
or joists are normally spaced 16 inches or
24 inches apart and are 1-1/2 inches in
width. To avoid surprises, be aware that
anything closer together or of a different
width may be an additional stud, joist or fire
break.
When working near AC electrical
wires, always turn off the power.
IMPORTANT SAFETY NOTICE
Insure proper detection of live wires
TM
ALWAYS hold the IntelliSensor Pro in the
handle area only. Grasp between fingers and
thumb while maintaining contact with your
palm.
Doors and windows are commonly
constructed with additional studs and
headers for added stability. The
IntelliSensorTM Pro detects the edge of
these double studs and solid headers and
emits and holds an audio signal as it crosses
over them.
9
9 17/2/05, 3:38 PM