Stanley IntelliSensor Pro Manuel D'instructions page 5

All manuals and user guides at all-guides.com
Operating Instructions
Battery Replacement
Calibration
Calibrating
109F Manual (B/E/F)
Open the battery door on back
of unit and connect a 9-volt
battery (not included) to clip.
Place battery back into case
and snap battery door on.
Recommend to replace a new
9 volt battery when low battery
Battery Door
indicator is on.
ILLUSTRATION 4
Calibrate the unit on wall before scanning
for wood or metal stud.
Note: While calibrating, the
TM
IntelliSensor Pro must not be placed
directly over a stud, dense material such as
metal, wet or newly painted areas as this
will prevent the unit from calibrating
properly. If this is done over wood or metal
stud the unit will give no indication when
moved away from the area. Move to a
different location and try again.
TM
Hold the IntelliSensor Pro flat against the
surface, making firm contact. Press and hold
the "ON" button. All indicators on the LCD
are displayed while the unit goes through
its' 1 to 3 second calibration cycle. The word
"CALIBRATING" will apear on LCD
(illustration 2) while the unit is calibrating
to surface. Following the completion of
calibration the unit will beep, and the word
"READY" will be shown on LCD
(illustration 5). The LED light will then
5 17/2/05, 3:38 PM