Makita DKP180 Manuel D'instruction page 10

1
► 1. Blade edge 2. Cutting line
Draw a cutting line on the workpiece. Insert the edge
fence into the hole in the front of the tool. Align the
blade edge with the cutting line.
1
► 1. Screw 2. Edge fence (optional accessory)
Adjust the edge fence until it comes in contact with the
side of the workpiece, then secure it by tightening the
screw.
When planing, move the tool with the edge fence flush
with the side of the workpiece. Otherwise uneven plan-
ing may result.
Maximum shiplapping (rabbeting) depth is 9 mm
(11/32").
2
You may wish to add to the length of the fence by
attaching an extra piece of wood. Convenient holes
are provided in the fence for this purpose, and also for
attaching an extension guide (optional accessory).
Chamfering
2
To make a chamfering cut as shown in the figure, align the "V"
groove in the front base with the edge of the workpiece and plane it.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
10 ENGLISH