Operation And Display - Volkswagen Driver Assistance System Manuel D'utilisation

Operation and Display

Function Multifunction Steering
Activate ACC
Set ACC Speed
Switch off ACC
temporarily
Resume ACC
Accelerate
(during ACC
control)
Decelerate
(during ACC
control)
Deactivate ACC
Increase/
Decrease
Distance to
Vehicle Ahead
Wheel Buttons
Forward Radar Systems
ACC Stalk Button or
Action
Action
The system is activated. Activation alone does
not result in a speed being stored, ACC is not
controlling the vehicle speed.
The current speed is stored and speed
regulation begins.
Speed regulation is temporarily deactivated.
The preferred speed remains stored.
Stalk:
• By pressing further, ACC turns off
The stored speed preference is resumed and
regulated. If no speed preference has been
stored, the ACC uses the current vehicle speed.
• Pressing briefly (pull on stalk) increases the
preset speed by 1 mph and stores it.
• Pressing and holding (up on the stalk)
increases the preset speed in 5mph
increments as long as the button is held.
• Pressing briefly (set on stalk) decreases the
preset speed by 1 mph and stores it.
• Pressing and holding (down on stalk)
decreases the preset speed in 5 mph
increments as long as the button is held.
• Pressing briefly temporarily cancels ACC
during active ACC control. Pressing briefly
again turns off ACC.
• Pressing and holding turns off ACC during
active ACC control.
• Pressing briefly increases the distance to
vehicle ahead by one increment.
• Pressing and holding cycles through
following distances.
Stalk:
• Roll to the right to increase distance to the
vehicle ahead.
• Roll to the left to decrease distance to the
vehicle ahead.