Sharp PN-325 Mode D'emploi page 19

nDimensional Drawings
Note that the values shown are approximate values.
When mounting the monitor, be sure to use a wall-mount/ceiling-mount bracket they comply with the VESA-compatible
mounting method. SHARP recommends using M6 screws and tighten the screws.
Loose holding may cause the product to fall, resulting in serious personal injuries as well as damage to the product. The
screw and hole should come together with 3/8 inch (10 mm) length of thread. Use the bracket which applied UL1678
standard, and which can endure at least 4 times or more the weight of the monitor.
nCompatible signal timing (PC)
Screen resolution
VESA 640 × 480
800 × 600
848 × 480
1024 × 768
1280 × 768
1360 × 768
Wide 1280 × 720
US TEXT 720 × 400
Sun 1024 × 768
* All are compliant only with non-interlaced.
* Depending on the connected PC, images may not be displayed properly even if the compatible signal described above is input.
* The frequency values for the Sun are reference values.
31-1/16 [789]
Opening width (27-9/16 [700.5])
Hsync Vsync Dot frequency
31.5kHz 60Hz 25.175MHz
37.9kHz 72Hz
37.5kHz 75Hz
35.1kHz 56Hz
37.9kHz 60Hz
48.1kHz 72Hz
46.9kHz 75Hz
31.0kHz 60Hz 33.75MHz
48.4kHz 60Hz
56.5kHz 70Hz
60.0kHz 75Hz 78.75MHz
47.8kHz 60Hz
60.3kHz 75Hz 102.25MHz
47.7kHz 60Hz
44.7kHz 60Hz
31.5kHz 70Hz
60Hz 64.13MHz
48.3kHz
53.6kHz 66Hz
56.6kHz 70Hz 74.25MHz
7-7/8 [200]
3-15/16 [100] 3-15/16 [100]
Analog Digital
Yes
Yes
31.5MHz
31.5MHz Yes
36.0MHz Yes
40.0MHz Yes
50.0MHz Yes
49.5MHz Yes
Yes
65.0MHz Yes
75.0MHz Yes
Yes
79.5MHz Yes
Yes
85.5MHz Yes
74.4MHz Yes
28.3MHz Yes
Yes
70.4MHz Yes
Yes
Specifications
Unit: inch [mm]
7-7/8 [200]
Screw holes for mounting brackets
(M6 x 12 holes)
Yes
Yes
Yes
-
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
-
-
-
17
E