Uline H-1069 Manuel D'utilisation

H-1069
6" CRIMPER
HAND SEALER
1. Attach the two metal clamp brackets (A) approximately
4½" apart to any straight-edge table with a depth 1½"
and height of up to 36". (See Figure 1)
Figure 1
2. Attach the silver link chain (B) to jaw bracket (C).
Holding the sealer jaws together, push the jaw
bracket pins up from the bottom of the sealer until
they snap into the channels on the top of the unit.
Position the bracket as close to the sealing jaws as
possible. (See Figure 2)
C
B
Figure 2
3. Rest the sealer on the clamp brackets. Attach the
other end of the chain to the "S" hook on the foot
pedal (D). (See Figure 3)
PAGE 1 OF 9
1-800-295-5510
uline.com
SETUP
A
C
4. Position the foot pedal directly underneath the
sealer and pointed away from you, so the tip with
the "S" hook is pointing toward the sealer (or table).
Leave enough tension in the chain so that the tip of
the pedal lifts 2-3" from the floor. (See Figure 3)
D
Figure 3
Para Español, vea páginas 4-6
Pour le français, consulter les pages 7-9
0124 IH-1069