Uline H-1091 Instructions D'installation

VINYL STRIP
DOOR KIT
TOOLS AND PARTS NEEDED
or
Hammer Drill Impact Drill
or
5/8" Drill Bit 5/8" Masonry
Drill Bit
GETTING STARTED
Open all carton(s) and remove all door hardware.
Do not remove PVC strips from the carton(s) until
ready for installation. All strip doors are shipped
complete with the following:
1. Mounting Bars (excluding support anchors)
2. Retaining Bars
3. 1/4" nuts and washers
4. Individual PVC strips with custom
pre-punched holes
Pre-studded aluminum Mounting Bars and Retaining Bars
are standard. Depending on the door width, more than
one mounting bar might be supplied.
1. Temporarily attach a PVC strip to either end of the
Mounting Bar(s).
2. Center and level the bar(s) above the opening so the
strips are 1/2" above the floor.
3. Mark Mounting Bar(s) anchor holes and remove the bar.
4. Drill anchor holes and place anchors (not included)
into those holes.
5. Take the temporary strips off the Mounting Bar(s) and
attach the Bar(s) with lag screws (not included).
PAGE 1 OF 6
7/16" Socket Bit
9/16" Socket Bit Tape Measure
WALL MOUNT HARDWARE INSTALLATION
Level
Ladder
Concrete Screw
MOUNTING PROCEDURES
The top edge of this aluminum hardware can be
attached 4⁄" above the edge of the door header
directly to the wall or directly to the door header.
Attach using conventional anchors.
Wall Mount
Mounting Bar
Mounting Bar
PVC Strips
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Utility Knife
or
Lag Bolt
Header Mount
Retaining Bar
0425 IH-1091