Product Description; Accessories; Intended Use; Installation And Connection - Oase 250 Notice D'emploi

- EN -

Product Description

Underwater Power Supply 250 is a controlled switching power pack that serves as a voltage supply for consumers with
a rated voltage of 25 V DC. A maximum of 250 Watt may be applied to the switching power pack.

Accessories

OASE 24 V DC/01 connection cable 1.0 m, 1.5 m, 3.0 m, 7.5 m, 15.0 m.

Intended use

Underwater Power Supply 250, referred to as "unit", may only be used as specified in the following:
• For use above and under water.
– Only use in conjunction with units intended by OASE for this purpose.
• Operate in accordance with instructions. (→ Technical data)
• Operation under observance of the permissible water quality. (→ Water quality)
• Pool water or salt water can impair the appearance of the unit. Such impairments are excluded from the guarantee.
The following restrictions apply to the Underwater Power Supply 250:
• Do not use in swimming ponds.

Installation and connection

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
Set-up the unit
The unit can be submerged in water or set up in a dry location, but must always be protected from direct sunlight.
How to proceed:
 A
1. Place the unit on a firm base.
– If the unit is installed outside the water: Ensure that there is a safety distance of at least 30 cm from combustible
material.
2. Bolt the unit to the base.

Connecting consumers

N O T E
Never connect or disconnect the plugs and sockets of the connection cables when they are under load! This
could damage the contacts.
• First isolate the unit (switch off and disconnect from the power supply), then start work on the unit.
• Max. 250 Watt total.
• Do not exceed the max. connected load. (→ Technical data)
• Adhere to the max. cable length per output (→ Technical data)
• Only connect cables from OASE to the outputs.
• Close off any unused sockets with protection caps and rubber seals.
N O T E
The device will be destroyed if water penetrates the sockets.
• Close off sockets with plug connectors or protection caps and rubber seals.
12