Scope Of Delivery; Product Description; Accessories; Installation And Connection - Oase LunAqua Power LED Driver Notice D'emploi

- EN -

Scope of delivery

The delivery scope includes:
• 1 × driver

Product Description

LunAqua Power LED Driver 30 W is a sturdy driver suitable for connection to up to four OASE LED spotlights of the
product range LunAqua Power LED. The driver permits simple and safe operation above and below water.

Accessories

LunAqua Power LED Cable 10 m (42636) as extension cable between driver and spotlight.
Intended use
Exclusively use the LunAqua Power LED Driver 30 W as follows:
• As a driver for OASE LED spotlights of the product range LunAqua Power LED.
• For use in water fountain systems and ponds.
• For use above and under water.
• Operate in accordance with instructions. (→ Technical data)
The following restrictions apply to the LunAqua Power LED Driver 30 W:
• Operation in swimming pools, bath tubs or water courses which could be used by persons, is forbidden!

Installation and connection

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
W A R N I N G
Death or serious injuries from hazardous electrical voltage due to operation of this unit in a swimming pond.
• Never operate this unit in a swimming pond.
 A, B
The device can be installed in or outside of the water.
Wall or floor installation
The driver can be fastened either to a stable wall or the ground (stable substrate).
• It is not permissible to fasten the driver to the ceiling.
How to proceed:
 C
1. Drill two holes with the indicated spacing.
2. Fasten the driver.
– Use suitable fastening materials.
10