Télécharger Imprimer la page

Home Decorators Collection GILES Serie Guide D'utilisation Et D'entretien page 10

Publicité

Les langues disponibles

Les langues disponibles

Operation (continued)
TIMER
The TIMER has adjustable setting at range from 30 minutes to 6 hours and OFF. The settings are: 30 minutes-1h-2h-3h-4h-5h-6h-OFF. If the
digital display turns on and nothing happens within 10 seconds, the digital display will auto shut off. Once you have set the timer, and the
timer is up, close all the functions and enter standby mode. In this mode, you should touch the power icon to restart the appliance.
INCREASE/DECREASE BUTTON
With the heater on, press the Increase/Decrease button to change the desired temperature.
There are 11 temperature settings:
ON - 64˚F - 66˚F - 68˚F - 70˚F - 72˚F - 74˚F - 76˚F - 78˚F - 80˚F - 82˚F
(ON - 18˚C - 19˚C - 20˚C - 21˚C - 22˚C - 23˚C - 24˚C - 25˚C - 26˚C - 27˚C).
Battery Replacement
NOTE:
□ Do not mix old and new batteries.
□ Do not mix alkaine, standard (carbon zinc), or rechargable (nicad, nimh, etc.) batteries.
□ Do not ingest batteries.
CAUTION:
□ Always purchase the correct size and grade of battery most suitable for the intended
use.
□ Replace all batteries of a set at the same time.
□ Clean the battery contacts and also those of the device prior to battery installation.
□ Ensure the batteries are installed correctly with regard to polarity (+ and -).
□ Remove batteries from equipment which is not to be used for an extended period of
time.
□ Remove used batteries promptly.
Care and Cleaning
□ Always turn the heater OFF and unplug the power cord from the outlet before cleaning.
□ Cleaning of the control panel, located in the upper right-hand corner of the fireplace behind the sliding control panel cover, is to be
done only using a soft cloth, slightly dampened in water (if needed, a small amount of dish soap can be added to the water) and dried
using a clean, dry soft cloth. Cleaning of the screen diffuser is to be done using only water and lint free cloth. DO NOT use any abrasive
cleaners on the diffusing screen.
□ The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and require no further
lubrication. However, periodic cleaning/vacuuming of the fan/ heater unit is recommended. Make sure the unit is turned OFF and
unplugged whenever you are cleaning the heater of fireplace.
10

Publicité

loading

Ce manuel est également adapté pour:

Giles 230-438-101001631505