Ayce HPG02E-15 Mode D'emploi page 31

Make sure that the distance from walls and objects is
respected.
1. Put the hanging rack on the wall as a guide ruler (please
make sure the holes at parallel level) , use a mark pen
to mark the hole position.
2. Drill holes on the wall with Ø 8mm drill bit and insert
the plastic wall plug.
3. Fasten the hanging rack on the wall with the screws,
do make sure the hanging rack is in correct direction.
4. Gently insert the heater body of the bottom to the
hanging rack first and then push the heater body to be
A
C
hooked on the whole hanging rack.
Warning: Be sure to keep the distance between the heater
and floor, wall and so on at least 30cm.
Warning! When drilling holes, Always check to ensure
there is no wiring, pipework, etc in the area to be drilled.
Warning: Before plugging in the unit make sure the
radiator is properly attached to the wall. Otherwise
problems can occur.
B
OPERATION:
Control panel and screen.

D
Button:
Power stand by / on
Increasing; Keep pressing for quick increasing; Forward
the hour in 24 hour program setting.
Decreasing; Keep pressing for quick decreasing;
backward the hour in 24 hour program setting.
Select mode or program
     
60 61
GB