CAMPAGNOLO SPEED 11 ERGOPOWER EPS CONTROL LEVERS Mode D'emploi page 22

1.1 - REAR BRAKE CABLE AND CASING
• Insert the brake cable (1.600 mm
long - ø 1.6 mm) in the ball bushing
on the brake lever of the EPS control,
making sure that the cable stop head
fits into its seat (Fig. 9).
• Depending on your frame, it may be
necessary to cut the rear brake casing
(1.250 mm long - ø 4.9 mm) and install
a casing end (ø 6 mm, not supplied
with the package).
• Fit the casing (without the casing
end) in the brake casing retainer and
secure the cable to the brake (refer to
the brake user manual).
1.2 - FRONT BRAKE CABLE AND CASING
• Insert the brake cable (800 mm long - ø 1.6 mm) in the ball bushing on the
brake lever of the Ergopower EPS control, making sure that the cable stop
head fits into its seat (Fig. 9).
• Fit the casing (580 mm long - ø 4.9 mm) in the brake casing retainer (without
the casing end) and secure the cable to the brake (refer to the brake user
manual).
WARNING!
After installation, make sure the wires and brake cables do not interfere
with the headset or with any other part of the bicycle. Interference may
affect your ability to turn or control the bicycle and may cause accidents,
personal injury or death.
22
9
ENGLISH