Connect The Battery; Engine Operations; Before Starting The Engine - Pro-Point 8999153 Mode D'emploi

8999153

CONNECT THE BATTERY

NOTICE! Do not reverse the polarity when connecting the
battery as as this will short circuit the battery charging
system or damage the equipment
The engine has an electric start option that requires a 12 volt battery
(sold separately). Use a 12V DC battery with a rating of at least 18
ampere-hours with the engine.
Battery cables are not included unless listed in the Unpacking Contents
section.
The polarity of each battery cable is displayed on a rubber cover where
they connect on either side of the starter motor.
1. Remove the wing nuts from the battery's positive (+) and negative
terminals (-).
2. Slide the positive battery cable lug onto the positive terminal. Coat
the cable end with grease and reattach the wing nut. Tighten hand-
tight.
3. Slide the negative battery cable lug onto the negative terminal.
Coat the cable end with grease and reattach the wing nut. Tighten
hand-tight.
4. Secure the battery so it won't move while the engine is in use.

ENGINE OPERATIONS

Check the engine's condition before operating to maximize the user's
safety and the service life of the engine. Ensure that the engine is
level and the switch is in the OFF position before beginning the pre-
operation checks.

BEFORE STARTING THE ENGINE

WARNING! Do not start or run engine in an enclosed
area, even if the doors or windows are open. Engine
exhaust contains carbon monoxide (see Carbon Monoxide
Precautions).
1. Make sure spark plug, air cleaner, fuel cap and muffler are in place
and secured.
www.princessauto.com / 1-800-665-8685
OHV GAS ENGINE
V1.4
Page 8