Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Leave ajar the casing and, if there are safety sensors, check that they are in standby mode and that there are no people or objects moving in the
sensors detection area.
6. Press the LEARN button for 2 seconds, the display flashes
Before performing any type of operation, make sure that the automation is turned off and the batteries are disconnected.
7. Free the area of action of the sensors so that they are detected and monitored during the learning cycle.
8. The automation performs opening and closing operations. At the end of the learning cycle, the door remains closed and the display indicates
If some parameters have not been automatically configured during the learning cycle, the door opens. The display first indicates
the parameter that has not been acquired automatically, for example, if the door is a 2-wing or 1-wing door (parameter 67).
1. Press the SELECT button to start to modify the parameters.
2. Press SELECT again to display the parameter value in flashing mode.
3. Select the correct value using the UP and DOWN buttons.
4. Press SELECT to confirm and program the selected value.
5. Continue to configure the other parameters that have not been acquired.
6. Press LEARN/EXIT for more than 2 seconds and the display will indicate
If necessary, you can adjust the following main parameters:
PARAMETER
00
High Speed Opening (cm/s)
02
High Speed Closing (cm/s)
03
Hold Open Time (00÷60s)
11
Partial Open Position (00-99%)
15
Run Program (01÷05)
Opening Max Force (02÷23N x10)
49
At the end of the start-up close the cover and fix it with the appropriate screws.
All the rights concerning this material are the exclusive property of Entrematic Group AB. Although the contents of this publication have been
drawn up with the greatest care, Entrematic Group AB cannot be held responsible in any way for any damage caused by mistakes or omissions
in this publication.
We reserve the right to make changes without prior notice. Copying, scanning and changing in any way are expressly forbidden unless authorised
in writing by Entrematic Group AB
EN
DESCRIPTION
, after 2 seconds, the door closes and is ready for operating.
10÷70cm/s
10÷70cm/s
Performance adjustment. Sets how fast or slow the door shall accelerate or break.
01= Smooth, for light doors
05= Max Performance. For heavy doors
If the reopening maneuver occurs too abruptly, set parameter 49 with a value lower
than the factory value (10), example 04 - 05.
8
SETTINGS
, and then
Publicité
Table des Matières
