Leb electronics CTR57 Manuel D'emploi page 25

Procedure of programming for a gate with two wings having the same stroke or with a single wing

Adjust RV1 trimmer clockwise up to the end of stroke and place both leaves up to full closing,

Press the key P3 for 3 sec. to enter in programming mode. Led DL1 issues a short flash and then it lights up with a steady light,

Without hesitation, press the key P3 for 1 sec., after a short time, M2 leaf opens at slow down speed up to the end of stroke (full opening),

Once reached the stroke end (full opening), M2 leaf closes at nominal speed up to the end of stroke (full closing),

Once reached the stroke end (full closing), M2 leaf stops. Working time of leaf M2 has been programmed. Working time of leaf M1 will be
programmed exactly as for leaf M2. End of procedure.
NOTE: In the case of a single wing gate, connect the motor at output M2 and place the dip-switch 5 in ON.
WARNING: full opening / closing, it means that the leaf has to bump against a mechanical stopper. Mechanical stopper can be a ground
centre blocker or a wall.
Pause time setting

Press the key P3 for 3 sec. to enter in programming mode. Led DL1 issues a short flash,

Without hesitation, press the key P3 for 1 sec., Led DL1 issues a short flash and then it lights up with a steady light,

Let pass the time corresponding to the desired pause and press again the key P3 to stop the time. Led DL1 will switch off, end of procedure.
Setting of delay in opening for leaf M1

Press the key P3 for 3 sec. to enter in programming mode. Led DL1 issues a short flash,

Without hesitation, press the key P3 for 1 Sec., Led DL1 issues a short flash,

Without hesitation, press again the key P3 for 1 Sec., Led DL1 issues a short flash and then it lights up with a steady light,

Let pass the time corresponding to the desired delay and press again the key P3 to stop the time. Led DL1 will switch off. End of procedure.
Setting of delay in closing for leaf M2

Press the key P3 for 3 sec. to enter in programming mode. Led DL1 issues a short flash,

Without hesitation, press the key P3 for 1 Sec., Led DL1 issues a short flash,

Without hesitation, press again the key P3 for 1 Sec., Led DL1 issues a short flash,

Without hesitation, press again the key P3 for 1 Sec., Led DL1 issues a short flash and then it lights up with a steady light,

Let pass the time corresponding to the desired delay and press again the key P3 to stop the time. Led DL1 will switch off. End of procedure.
25
ENGLISH