Outputs; Power Supply; Accessories - Leb electronics CTR57 Manuel D'emploi

ENGLISH
3) Definition of outputs
Blinker (LAMP)
Control on/off of a lamp intended to optically signal danger condition due to moving gate.
The blinker starts up for 1,5 sec. before the motor start (alert). Blinking logics are the following ones:
Fast flashing (2 flashings/sec.): signals the opening step
Slow flashing (1 flashing/sec.): signals the closing step
Fixed light: signals that the gate is stopped, waiting for the removal of the obstacle darkening the photocell, the photostop or the side .
Fast flash (2 flashes/sec.): signals missing connections on the side input.
Very slow flashing (1 flashing/3 sec.): signals the missing net power while working with buffer battery connected.
Motor 1 (MOT1)
Outputs for the control open / close of the motor connected to the first gate wing in closing step.
Motor 2 (MOT2) - to be used on single wing gates
Outputs for the control open / close of the motor connected to the gate wing delayed in closing step.
4) Definition of power supply
VIN (FS1 - FS2)
Input 20Vac for feeding of the electronic card and the motors.
VOUT
Output 12Vdc for feeding of photocells and/or other accessory devices.
BATT IN (FS3 - FS4)
Input for the connection of a 24Vdc buffer Battery.
Warning: make sure the jumper JP1 is in the right position in order to avoid serious damages to the equipment and/or the battery.

5) Accessories

Aerial (ANT)
Input for the connection of a radio receiver aerial.
6) Definition of optical signals
DL1 - Programming Led (red): It switches on in programming step and during gate motion.
DL2 - Stop Led (red): It switches off at a stop control in terminal board.
DL3 - Photostop Led (yellow): It switches off when the photoelectric cell is darkened.
DL5 - Photocell Led (yellow): It switches off when the photocell is darkened.
DL6 - Start Led (green): It switches on at a start control in terminal board.
DL7 - Net Led (green): It switches on with 20Vac power on the input VIN.
7) Definition of trimmer
RV1 – Amperometric regulation
It regulates the intervention threshold of amperometric sensor during fast speed.
18