VESTEL IF75T633/6 Manuel D'utilisation page 18

No Signal Delay
No signal Power
off
Panel Lock
RCU Inhibit
UART 0
UART 1
Embedded Touch Enables or disables the functionality of the embedded touch screen.
Power Up Settings
Power Up Mode
Quick Standy
Power on Delay
Auto Launch
Boot Up Picture
Mode
HDMI1 Wake Up
Enabled
USB
Clone to USB
Clone from USB
Sets a delay value to the 'No Signal' preferences when the Display is in No Signal state.
After the set delay time is expired 'No Signal' preferences will be applied.
When enabled the Display will turn itself off after a period of 5 minutes, if no signal is
received from the selected source.
This feature will only work if all of the following circumstances occur:
- No Signal option is set as Failover.
- USB device is not connected to the Display / USB device is connected but there are
no playable files installed in the USB device.
Set as Off to prohibit the use of the buttons on the Display.
Set as On to inhibit the use of the remote. Remote control will function in Stand-By
mode independently from the setting of this option.
To turn this option off and be able to use the remote again, press MENU/M-1-9-7-3
buttons on the remote consecutively. Signage Settings menu will appear. Enter the
Controls menu and set this option as Off.
Select ASCII/HEX protocol for UART 0. Default value is ASCII. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
selection is changed, the latest selected protocol will be preserved and started when
the Display is booted up.
Note that ASCII/HEX selection is not working while debug logs are enabled. If it is
wrongly changed to HEX while debug logs are enabled, revert the selection to ASCII and
reboot the Display in order to correct the debug logs and the ASCII protocol behaviour.
Also note that HEX protocol will work with the baud rate value 19200 for UART0
Select ASCII/HEX protocol for UART 1. Default value is HEX. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
selection is changed, the latest selected protocol will be preserved and started when
the Display is booted up.
Note that ASCII/HEX selection is always working as expected. It does not matter if the
debug logs are enabled or not.
Also note that HEX protocol will work with the baud rate value 9600 for UART1
Configures the power up mode preference. Last State, Always On and Standby
options are available.
If this feature is enabled the Display can be turned on again with the RS232 and Lan
commands if it is turned off through it. Press Left or Right button to enable or disable
the feature.
Sets a delay value at power on. This value can be set from 0 to 2000 ms in steps of 100
ms. The Display will turn on after the set delay time is expired.
Configures the auto launch preference. CMS(Start url), Open Browser(Open Browser
initial page) and Disabled options are available.
Configures the picture mode preference at power on. If set as Off the last set picture
mode will be used at power on.
If this option is set as Enabled, the Display will turn on with the HDMI input source,
when it is switched on. This feature works based on HDMI 5V signal. When this signal
is active the Display wakes up and when the signal is inactive the Display shuts down.
You can disable this option by setting as Disabled.
If any Scheduler is set or an OPS unit is connected to the Display, this option will be
inactive and can not be set as Enabled.
Note: This feature may not be available depending on the model of your unit.
Copies the database files from the unit to a connected USB device.
Copies the database files from a connected USB device to the unit.
English - 16 -