Hama EWS-180 Mode D'emploi page 5

• Hang up the base/measuring station using the opening (17/21)
intended for this purpose.
6. Operation
Note – Input
Hold down the ▲ button (13) or the
the values faster.
6.1 Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and performs
initial setup.
Note
• Initial setup takes approx. 2 minutes.
• During connection, the wireless symbol on the measuring
station will flash (1).
• Do not press any buttons during setup. Otherwise, values
may not be transmitted correctly and there is a risk of value
errors and inaccuracies.
• The setup process is completed when the indoor (3) and
outdoor (2) measurement data is displayed.
• The measured value is automatically updated by the base
device about every 45 seconds.
Display
Display flashing
Displayed continuously
Displayed continuously
• If the base station still does not receive a signal from the
measuring station, press and hold the
3 seconds to start the manual search for the signal.
4
▼ button (16) to select
Search for a signal from
the measuring station
Active
Successful –
signal is being received
Inactive –
no signal reception
▼ button (16) for approx.
6.2 Basic and manual settings
Automatic setting using the DCF signal
After the first time the base station is switched on and successful
transmission is established between the base station and the
measuring station, the clock will automatically search for a DCF
signal. During the search, the wireless symbol (6) will flash.
Display
/
Display flashing
Displayed continuously
Displayed continuously
• If the station still does not receive a signal, press and hold the
button (13) for approx. 3 seconds to start the manual search
▲
for the DCF signal. The wireless symbol (6) will start to flash.
Note – Time settings
• The search process takes about 3-5 minutes. If the search
fails, it ends and is repeated at the next clock hour. The
radio symbol (6) disappears.
• In the meantime, however, you can set the time and the
date manually.
• The clock automatically continues to search for the DCF
signal every hour. If the signal is received successfully, the
manually set time and date are overwritten.
• Press and hold the ▲ button (13) again for approx. 3 seconds to
stop the manual search. The radio symbol (6) disappears.
Note – Summer time
The clock automatically switches to summer time.
appears on the display as long as summer time is activated.
Searching for the DCF signal
Active
Inactive –
no signal reception
Successful –
signal is being received
(3)