Makita DT 2000 Instructions De Montage page 8

H
I
5
6
II
I
1 2
3
J
3
1
K
8
2
1 3
4
7
4
2 - 3 mm
2
B
A
Mounting the power cut
Place the guide trolley with the control shaft onto the floor.
Place one foot firmly on the control shaft.
Hold the power cut firmly as shown in the picture and hook on
the clamp bracket (1) on both sides; pull backwards as far as
it will go, swivelling the hand protector device (2) over the sup-
port plate (3).
Press the power cut between the two supports (4) onto the
support plate.
Fold out (I) the holding brackets (5) and secure (II) using the
eccentric plate (6).
Lock the eccentric plate in place using the quick-action lever
(7).
5
Setting the gas lever
Turn the gas lever (1) back as far as it will go (parallel to the
control shaft).
Loosen screw (2) on gas lever.
Take hold of cable end (3) and pull until the distance between
the gas operating device (5) and the gas lever on the power
cut (4) is about 2-3 mm.
Clamp cable with screw (2).
Adjusting the cutting line
If the guide trolley pulls to the left or right of the straight cutting
line when you are cutting with the power cut, this can be cor-
rected by pushing aside the support plate (1).
Loosen the nuts on the screws (2).
Loosen the quick-action lever (3).
Pushing the support plate (1) in the direction A corrects cut-
ting to the left.
Pushing the support plate (1) in the direction B corrects cut-
ting to the right.