Topping Up The Oil-Dynamic Circuit; Device Disposal - FAR FHU 05 Mode D'emploi

FHU 05

TOPPING UP THE OIL-DYNAMIC CIRCUIT

You need to top up the hydraulic circuit after a long period of work, when you note a power loss. Put the riveting device (DWELL
AND NOT FED) in a horizontal position and remove the plug (A), by means of a 5 mm Allen wrench (equipped with the riveting
device); during this operation, check the oil level in order to avoid any overflowing. Then, slowly pour the oil PANOLIN HLP
ISO 32 into the bellows container (X) which shall be screwed into its seat on the plug (A).While keeping the riveting device in a
horizontal position and starting air feeding, push the tensile strength button and make the riveting device carry out some cycles
until air bubbles inside the container (X) stop coming out. This condition indicates that the topping up of the oil has fully been
achieved. At this point, while keeping the riveting device in a horizontal position, unscrew the oil container (X) and close it again.
Do not push the tensile strength button during this operation. Go on by closing the oil tank plug (A).
WARNING! It is very important to follow the above mentioned instructions and use gloves.If the hydraulic circuit should be fully
emptied, collect the oil in a suitable container and contact an authorized Company for its disposal.
WARNING!
• Before disconnecting the compressed air hose, make sure that it is not under pressure!
• Make sure that the oil filler cap (A) is tightened at a torque corresponding to Min. 5 Nm ÷ Max. 8 Nm.
• We recommend to use oil PANOLIN HLP ISO 32 DIN 51524-2/HLP or similars.
A

DEVICE DISPOSAL

For the device disposal, comply with the national laws. After disconnecting the device from energy sources, start
the disassembly of the components according to their material: steel, aluminium, plastic and so on.
Go on with the scrapping in accordance with the nationl standards.
Revisione - 05
min. 5 Nm
max. 8 Nm
GB
Date 01-2012
X
9