Uline H-5059 Guide Rapide

H-5059
BIG AND TALL
SLED BASE CHAIR
WITH ARMS
TOOL NEEDED
Phillips Screwdriver
Seat Cushion x 1
1. Align leg mounting plates with holes on bottom of
seat cushion. Use four M8 x 25 mm screws to secure
loosely. Repeat on opposite side. (See Figure 1)
NOTE: Do not tighten screws until assembly is
complete.
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
Back Cushion x 1 Leg with Armrest x 2
M8 x 25 mm screw
PARTS
M8 x 25 mm Screw x 8
ASSEMBLY
2. Align back cushion with holes in back mounting
plates. Use four M6 x 25 mm screws to secure loosely.
(See Figure 2)
Figure 2
M6 x 25 mm
screw
3. Use Phillips screwdriver to fully tighten all screws.
Para Español, vea página 2.
Pour le français, consulter les page 3.
Hardware Kit
M6 x 25 mm Screw x 4
0521 IH-5059