Fitting The Cover; Removing The Cover; Function Check; Warnings - Truma S 3004 Instructions De Montage

Masquer les pouces Voir aussi pour S 3004:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25

Fitting the cover

Hook cover into the lower bearings (1) and swivel in (2) until
catch audibly engages. Pull to make sure the cover is firmly
attached.
1
Figure 19

Removing the cover

Possible burn injury hazard if contact is made with the
hot heater. Do not remove the cover unless the heater
is switched off and has cooled down.
The cover is unlocked by pushing the two locking levers (64)
outwards simultaneously. It can be swivelled out and lifted
from the lower bearings.
64
Figure 20
24

Function check

Possible injury / material damage if the heater is oper-
ated without a cover. Operate the heater only with the
cover fitted.
Following installation, the gas system must be checked for
leaks in the first inspection by using the pressure drop method
in accordance with EN 1949.
Version with lighting
The sensor electronics of the lighting calibrate themselves
whenever the 12V supply voltage is applied. This can take
several seconds. Do not touch the cover during calibration.
2
Then check all appliance functions as described in the operat-
ing instructions.
The operating instructions must be handed over to the vehicle
owner.

Warnings

The stickers enclosed with the appliance must be affixed by
the installer or vehicle owner in a location in the vehicle that is
clearly visible to all users! Missing stickers can be requested
from Truma.

Technical data

(determined in accordance with EN 624 or Truma test
conditions)
S 3004 / S 5004
Gas type
Liquefied gas (propane / butane)
Operating pressure
30 mbar (see type plate)
Rated heat output
S 3004: 3500 W
S 5004: 6000 W
Gas consumption
S 3004: 30 – 280 g/h
S 5004: 60 – 480 g/h
Additional information in accordance with EN 624
S 3004: Q
S 5004: Q
Appliance
category
I
3B/P(30)
I
3+(28-30/37)
Operating voltage
1.5 V (auto ignitor with battery operation)
Power consumption
225 mW (ignition)
Weight
S 3004: approx. 10.3 kg (without fan)
S 5004: approx. 17.5 kg (without fan)
S 3004:
Subject to technical changes.
= 4.0 kW (Hs); 290 g/h; C
n
51
= 6.8 kW (Hs); 490 g/h; C
n
51
Destination countries
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI,
FR, GB, GR, HR, HU, IE, IS, IT, LI, LT, LU,
LV, MT, NL, NO, PL, PT, RO, SE, SI, SK, TR
BE, CH, CZ, ES, FR, GB, GR, IE, IT, PT, SI
S 5004:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

S 5004

Table des Matières