SOMFY Amy 1 RS100 io Notice page 5

Amy 1 RS100 io
2.1.Mode selection
The mode selector is used to deactivate or activate the Low Power Mode (LPM)
depending on the type of motorised products being controlled. The Low Power Mode
has to be activated if is associated with autonomous drives or low consumption
drives (compatible only with Somfy autonomous products).
NOTICE
• By default, the Low Power Mode is activated on Amy 1 RS100 io.
• Deactivating the Low Power Mode increases the autonomy of Amy 1 RS100 io and reduces radio communication
and any associated interference.
1] To check if Low Power mode is activated or deactivated:
Press and hold the mode selector (more than 2 seconds) to see the color of the
settings feedback LED flash corresponding to the currently selected Low Power mode
management.
LED color and number of flashes
Green LED blinks 1 time
Red LED blinks 1 time
2] To activate/deactivate Low Power mode:
Briefly press once or twice in succession the mode selector to activate or deactivate
Low Power mode.
Number of short presses
Briefly press 1 time
Briefly press 2 times
2.2.Adding/Deleting Amy 1 RS100 io
NOTICE
To program the first control point, refer to the instructions for the io drive or receiver.
The procedures for adding or deleting Amy 1 RS100 io are the same.
NOTICE
It is advisable to do next steps with front panel buttons deactivated to avoid sending unwanted commands by
manipulating the module (refer to Switching on Amy 1 RS100 io).
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
>2 s
Low Power mode management
LPM activated
LPM deactivated
0.5 s
Low Power mode management
LPM activated
LPM deactivated
EN
5