Electrical Safety Precautions - Pro-Point 9027970 Mode D'emploi

9027970
suddenly bend outward or break.
12. Do not use wire wheels, router bits, shaper cutters, circle (fly)
cutters, or rotary planers on this drill press.
13. When cutting a large piece of material, make sure it is fully
supported at the table height.
14. Do not perform any operation freehand. Always hold the workpiece
firmly against the table so it will not rock or twist. Use clamps or a
vise for unstable workpieces.
15. Ensure there are no nails or foreign objects in the part of the
workpiece to be drilled.
16. Securely lock the head and table support to the column, and the
table to the table support before operating the drill press.
17. Never turn your drill press on before clearing the table of all objects
(tools, scraps of wood, etc.).
18. Before starting the drill press, jog the motor switch to make sure
the frill bit does not wobble or vibrate.
19. Let the spindle reach full speed before starting to drill. If your drill
press makes an unfamiliar noise or if it vibrates excessively, stop
immediately, turn the drill press off and unplug. Do not restart the
unit until the problem is corrected.
20. Do not perform layout assembly or set up work on the table while
the drill press is in operation.
21. When drilling large diameter holes, clamp the workpiece firmly to
the table. Otherwise, the bit may grab and spin the workpiece at
high speeds. Do not use fly cutters or multiple-part hold cutters, as
they can come apart or become unbalanced in use.
22. Ensure the spindle has come to a complete stop before touching
the workpiece.
ELECTRICAL SAFETY
PRECAUTIONS
WARNING! ALWAYS use proper circuit protection. Use a separate
electrical circuit for your tools. To avoid shock or fire, if power
cord is worn or cut, or damaged in any way, have it replaced
immediately. If you use this tool unsafely or incorrectly, you can
6
20 in. Floor-Mount Drill Press
For technical questions call 1-800-665-8685
V1.1