Personal Safety; Personal Protective Equipment; Personal Precautions - Pro-Point 9027970 Mode D'emploi

9027970
4. Do not install or use in the presence of flammable liquids or gases
or areas prone to dampness or rain.
5. Always operate the drill press in a well-ventilated area and provide
for proper dust removal.

PERSONAL SAFETY

WARNING! Wear personal protective equipment approved by the
Canadian Standards Association (CSA) or American National
Standards Institute (ANSI).

PERSONAL PROTECTIVE EQUIPMENT

1. Always wear impact safety goggles that provide front and side
protection for the eyes. Eye protection equipment should comply
with CSA Z94.3-07 or ANSI Z87.1 standards based on the type of
work performed.
2. Wear the appropriate type of full-face shield in addition to safety
googles, as the work can create chips, abrasive or particulate
matter.
3. Do not wear gloves when operating a tool that can snag the
material and pull the hand into the tool.
4. Wear protective clothing designed for the work environment and
tool.
5. Non-skid footwear is recommended to maintain footing and
balance in the work environment.

PERSONAL PRECAUTIONS

Control the tool, personal movement and the work environment to avoid
personal injury or damage to the tool.
1. Do not operate any tool when tired or under the influence of drugs,
alcohol or medications.
2. Avoid wearing clothes or jewelry that can become entangled with
the moving parts of a tool. Keep long hair covered or bound.
3. Do not overreach when operating the tool. Proper footing and
balance enable better control in unexpected situations.
4. Support the workpiece or clamp it to a stable platform. Holding the
workpiece by hand or against your body may lead to personal
injury.
4
20 in. Floor-Mount Drill Press
For technical questions call 1-800-665-8685
V1.1