Kenwood KDC-DAB43U Guide De Démarrage Rapide page 11

4
Remove the separator (tag II) of
antenna film F vertically and paste
the antenna gently while applying
pressure.
5
After pasting, rub the element in the
glass surface in the direction of the
arrow shown in the figure to bond it.
6
Remove the application film (tag III).
– Do not touch the feeder terminal of the
element. Also, do not apply any glass
cleaner.
Feeder terminal
7
Match the protrusion of the amplifier
G with the R on the antenna film F
and paste.
– Do not touch the feeder terminal or the
pasting surface (adhesive side) of the
amplifier.
• When installing the antenna on the
right side
Match the protrusion with R
Earth sheet
Antenna film
F
Amplifier G
• When installing the antenna on the
left side
Antenna film F
Amplifier G
Earth sheet
Match the protrusion with R
8
Remove the film covering the earth
sheet and paste the earth sheet on
the metal part of the vehicle.
Provide sufficient leeway for the earth
sheet so that it does not interfere with
the interior parts (front pillar cover).
Also take care that the interior parts do
not interfere with the amplifier G.
Front glass
Amplifier G
Front pillar
Interior part
Earth sheet
9
Wire the antenna cables.
Use cord clamper H to secure the
antenna to the pillar at several locations.
Notes
Take the following precautions when
passing the antenna cable inside the front
pillar where the air bag is installed.
• Install the amplifier part of the antenna
cable in front or above the air bag so
that the antenna and the air bag do not
interfere.
Amplifier G
Air bag
Front pillar
• The front pillar cover is secured with
a special clip which may need to be
replaced when the front pillar cover is
removed.
Contact your vehicle dealer for details
on replacing the front pillar cover and
availability of replacement parts.
Interior part
Clip
Select the DAB antenna power
Set "INITIAL SET" > "DAB ANT PWR" to
"ON" in STANDBY mode. (page 6)
English | 11