Nyne NB-200 Manuel Utilisateur page 12

Slide the power switch on
the back of the device to
the ON position.
☞
The power indicator on the
front of the device lights up.
☞
You can hear a beep after
a while.
To turn off the device:
Slide the power switch on
the back of the device to
the OFF position.
Pair with a Bluetooth-enabled device
Before using the Bluetooth
time, you need to pair NB-
200 with another Bluetooth-
enabled device, such as an
iPod/iPhone/iPad, Android
smartphone, PC, or Mac.
After successful pairing, each
time when the paired device
200 are powered on and within
or 10m), you can press
NB-200 to activate Bluetooth
connection between them.
12
EN
NYNE_NB-200_User Manual_A6_V1.1.indb 12
Notes:
If your paired device fails
to connect with NB-200
after activation, you may
need to select the device
name of NB-200 from the
list of Bluetooth equipment
on your paired device to
set up wireless connection
again.
Make sure that NB-200
and the device to be
paired are located within
the detectable range
Make sure that the
3.5mm audio cable is not
connected to NB-200.
1
Enable the Bluetooth
on
function on your device to
be paired with NB-200.
☞
The device to be paired
with NB-200 enters
Bluetooth searching mode.
5/27/2012 9:12:25 PM