Radio Operation - Steute Rf 96 St Sw868 Instructions De Montage Et De Câblage

RF 96 ST SW868/SW915/SW917/SW922
Montage- und Anschlussanleitung / Funk-Universalsender
Mounting and wiring instructions / Wireless universal transmitter
Instructions de montage et de câblage / Emetteur universel sans fil
Istruzioni di montaggio e collegamento / Trasmettitore universale wireless
Instruções de montagem e instalação / Transmissor universal sem fio
English

Radio operation

The transmission of a switching command from the transmitter to the
receiver takes about 80 to 100 ms, based on the sWave ® data trans-
mission. The switching signal of a transmitter must not be generated
at a shorter distance, otherwise this signal will be overlooked. The re-
ceiver must support the sWave ® protocol of the steute modules. Each
switching operation triggers a transmission from the radio unit. This
also applies if several channels are activated or deactivated simulta-
neously. The current value of the battery voltage is transmitted with
each transmission.
Safety
Do not use the device in connection with other devices whose direct or
indirect purpose is to ensure life or health, or whose operation may
pose a threat to humans, animals or material assets.
Maintenance and cleaning
.steute recommends routine maintenance as follows:
1. Remove all dirt particles: Clean enclosure on the outside only.
Clean device in accordance with IP protection class. Clean with
a soft cloth and water or a mild detergent.
Do not clean using compressed air.
2. Remove dust from sensor surfaces.
3. Replace damaged parts.
4. Test the function.
Battery
The remaining capacity of a battery is hard to evaluate, but an empty
battery can be assumed in case of doubt and with a battery voltage
approx. <3.4 V at 20°C. In order to ensure reliable functioning, the bat-
tery must be replaced. To do this, the 5 screws in the housing cover
must be opened using a torx-8 screwdriver. The battery should be
inserted in the direction shown by the symbols on the cover. Only use
the intended or a compatible battery type. Depending on the country
of delivery, delivery will include either no battery or an AA lithium bat-
tery SL-760/3.6 V/2.2 Ah in a battery adapter, or a lithium battery SL-
2770/3.6 V/8.5 Ah without an adapter.
Spare part:
Name
Lithium battery SL-2770/S 3.6 V/8.5 Ah
Lithium batteriy SL-760 (3.6 V/2.2 Ah AA)
Disposal
- Observe national, local and legal regulations concerning disposal.
- Recycle each material separately. Dispose of possibly contained
batteries correctly.
Status signal
A status signal can be set by the user at various intervals with the
jumper. To do this, open the enclosure by removing the 5 cover screws
using a Torx 8 screwdriver. Take care to ensure sufficient ESD protec-
tion. Inside the enclosure a jumper is located on the circuit board. Ad-
just to the desired interval. For evaluation of status signals, steute pro-
vides special receivers.
delivery state:
no status signal
Jumper
without jumper or 1 and 2
Position 1
Position 2
Position 3
Position 4
After successful adjustment replace the enclosure cover and tighten
the cover screws with approx. 0.45 Nm. The sealing must not be con-
taminated by any foreign bodies.
N.B.
Subject to technical modifications. Reconstruction and alterations to
the device are not allowed.
ESD
Ensure adequate ESD protection for all work that requires opening
the device.
Article no.
1202806
1351045
4 / 20
example position 1:
status signal every 10 s
Intervall
no status signal
10 s
100 s
1,000 s
10,000 s