IKEA JETSTROM Manuel D'instructions page 4

English
Getting started
Connect your product to the mains or plug
the power cable into the wall socket.
Before you can use your light source you'll
need to pair it with a steering device.
1. Make sure that your light source is
installed and the main power switch is
turned on.
2. Hold the steering device close to the
light source you want to add (no more
than 5 cm away).
3. Press and hold the pairing button
at least 10 seconds. A red light will shine
steadily on the steering device. Your
light source will begin to dim and finally
flash one time to indicate that it has
been successfully paired.
Up to 10 light sources can be paired with
1 steering device. Make sure to pair them
one at a time. If the light sources are close
to each other, disconnect those that have
already been paired from the main power
switch.
With the remote control you can switch
between 9 colours and white lights. With
the IKEA smart hub and the IKEA Home
smart app, you get a total of 20 colours
and white lights.
If you have the TRÅDFRI gateway or
DIRIGERA hub
Go to App Store or Google Play and
download the IKEA Home smart app. The
app will take you through the process of
installing your product and other devices.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS.
This light source will not operate
properly when connected to a standard
(incandescent) dimmer or dimming
control. Only controllable by IKEA Smart
lighting products.
4
How to factory reset your product
If the product does not respond or if
you want to un-pair the product from a
steering device you might have to make
a factory reset. The product is forced
to factory reset by carefully inserting
a paper clip end or similar in the small
hole (marked RESET) and apply a slight
pressure.
IMPORTANT!
• The product is for indoor use only and
can be used in temperatures ranging
from 5 °C to 40 °C (41°F to 104°F).
for
• Do not leave the product in direct
sunlight or near any heat source, as it
may overheat.
• The declared radio range between the
unit and the steering device is measured
in open air.
• Different building materials and
placement of the units can affect the
wireless connectivity range.
Care Instructions
Wipe clean with a damp cloth. Never use
abrasive cleaners or chemical solvents as
this can damage the product.
Save these instructions for future use.
Technical data:
Type: L2205, L2206 JETSTRÖM
Input: 220-240 VAC, 9.5W
Max lumen output: 1150 lm
Radio range: 10 m in open air.
Operating frequency: 2405-2480 MHz
Output power: Max 8.5 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult,
SWEDEN