Contents Of Delivery; Description Of Machine; Transport And Start Up; Transport And Installation - Jet Tools JTS-315LA-M Mode D'emploi

Acoustic pressure level (according to EN ISO 11202):
Idling
Operating
The specified values are emission levels and are not
necessarily to be seen as safe operating levels. This
information is intended to allow the user to make a better
estimation of the hazards and risks involved.
4.3 Content of delivery
Machine stand
Rear table extension
Rip fence
Sawblade dia 315mm
Raving knife
Saw guard
Dust connection hose and Y‐adapter
2 Wheels
2 Carry handles
Push stick
Operating tools
Operating manual
Spare parts list
4.4 Description of machine
LpA 83 dB(A)
LpA 93 dB(A)
Fig 1
Fig 2
A ........ Saw guard
B ........ Table insert
C ........ On/Off switch
D ........ Carry handle
E . ........ Dust connection hose
F . ........ Raving knife
G ........ Rip fence
H ........ Tilting handle
I . ......... Blade rising handle
J ......... Leg stand
K . ........ Blade
L ......... Rear table extension
M ....... Machine Table
N ........ Support rods
O ........ Side struts
P . ........ Rubber feet
Q ........ Chip box
R ........ Wheel axle
S . ........ Dust port
T . ........ Motor Assembly
U ........ Diagonal strut
5. Transport and start up
5.1 Transport and installation
Never lift the tool on it's guards.
The sawblade must be covered by the saw guard during
transport.
The machine is designed to operate in dry rooms and must be
placed stable on firm and levelled ground.
For packing reasons the machine is not completely assembled.
WARNING:
To avoid injury, if any parts are missing, do not attempt to
assemble the machine, do not plug in the power cord, do not
turn the switch on until the missing parts are obtained and
installed correctly.
5.2 Assembly
Assemble tool in strict accordance with these instructions.
Only if you follow the instructions exactly does the machine
conform to the safety regulations and can be safely operated.
If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Requirements for machine assembly:
‐ Philips screwdriver
‐ 22mm wrench
‐ 16mm wrench
‐ 10mm wrench
‐ 8mm wrench
‐ 6mm Internal Hex. Wrench
‐ pair of work gloves
Stand assembly:
To assemble the stand:
It is imperative that the leg (J) with opening for the switch (C)