Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1) Switch automation system off and on.
2) Set trimmer PM2 (chain dip setting) to the middle setting.
3) Press start and wait. The automation system performs the reset procedure.
4) At the end of the reset procedure, press START again and wait for the closing cycle to conclude.
5) Adjust trimmer PM2 to set the desired chain height and perform an open cycle and a close cycle to check that the height is correct.
9. SETTING THE TRIMMERS
PM1: PRE-MANOEUVRE WARNING LAMP FLASH TIME. Sets the pre-manoeuvre warning fl ash time between 2 and 10 sec.
PM2: CHAIN DIP. Sets chain height. Turn clockwise to increase height.
PM3: PAUSE TIME. Sets the pause time between 2 and 120 sec.
10. RADIO RECEIVER
Use an antenna tuned to 433MHz. Connect the tuned antenna to the antenna terminals using RG58 coaxial cable .
ANTENNA
SHIELD
In the case of standard installations where no advanced functions are required, it is possible to proceed to manual
storage of the transmitters, making reference to programming table A and to the example for basic programming.
1) If you wish the transmitter to activate output 1, press pushbutton PR1, otherwise if you wish the
transmitter to activate output 2, press pushbutton PR2.
2) When LED DL1 starts blinking, press hidden key on the transmitter, LED DL1 will remain continuously lit.
3) Press the key of the transmitter to be memorized, LED DL1 will fl ash quickly to indicate that it has been
memorized successfully. Flashing as normal will then be resumed.
4) To memorize another transmitter, repeat steps 2) and 3).
5) To exit memorizing mode, wait for the LED to go off completely or press the key of a remote control that
has just been memorized.
IMPORTANT NOTE: ATTACH THE ADHESIVE KEY LABEL TO THE FIRST MEMORISED TRANSMITTER (MASTER).
In the case of manual programming, the fi rst transmitter assigns the key code to the receiver; this code is necessa-
ry in order to carry out subsequent cloning of the radio transmitters.
This mode is used to copy the keys of a transmitter already stored in the receiver memory, without accessing the
receiver.
The fi rst transmitter is to be memorised in manual mode (see paragraph 10.4).
a) Press hidden key on the transmitter already memorised.
b) Press key T on the transmitter already memorised, which is also to be attributed to the new transmitter.
c) Within 10 s., press hidden key on the new transmitter to be memorised.
d) Press key T to be attributed to the new transmitter.
e) To memorise another transmitter, repeat the procedure from step (c) within a maximum time of 10
seconds, otherwise the receiver exits the programming mode.
f ) To copy another key, repeat from step (a), having waited for the receiver to exit the programming mode
(or after disconnecting the receiver from the power supply).
8.2 CHAIN HEIGHT ADJUSTMENT
10.1 RECEIVER TECHNICAL SPECIFICATIONS
- Max. n° of radio transmitters that can be memorized:............................................2048
- Frequency:..................................................................................................................433.92MHz
- Code by means of:...........................................................................Rolling-code algorithm
- N° of combinations:.......................................................................................................4 billion
10.2 RADIO CHANNEL FUNCTIONALITY
Channel 1: START command
Channel 2: AP.PD command (Semi-automatic opening cycle)/CHIUDI
10.3 ANTENNA INSTALLATION
10.4 MANUAL PROGRAMMING
10.5 SELF-LEARNING MODE PROGRAMMING
Control unit
antenna cable RG58
- 13 -
EN
Hidden key
Hidden key
T1
T2
T3
T4
Publicité
Table des Matières
