Coshh; Control Of Substances Hazardous To; Water Flow Adjustment; Pre-Cleaning Advice - Numatic TTB 1840 Mode D'emploi

!
WHEN HANDLING AND MIXING CHEMICALS.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specification.
For further guidance on hazardous substances refer to health and safety instructions online.

Water Flow Adjustment

Fig.14
!
Important
Do not operate machine unless the Operator Manual has been read and fully understood.

Pre-cleaning advice.

Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig.16).
Numatic part (629044) Wet Floor sign
(available if required)
Machine Set-Up
Located on the left of the machine is the On / Off water tap
(Fig.14).
Ideally set the tap to 45º this enables the cleaning
solution to last the same time as a fully-charged battery
(Fig.15).
45º
Fig.15
26
!
!
Fig.16