Tolerance Check For Target Weight - KERN SFB Série Mode D'emploi

Optical signal:
Three colour pilot lamps indicate whether load is within the two tolerance limits.
The signal lamps provide the following information:
+

-
Settings for tolerance weighing may be set either by calling up menu block "P0 CHK"
(See chap. 8) or by applying the faster option of pressing the key combination
7.7.1

Tolerance check for target weight

Settings
 Press and
 Press until the display for entering the lower limit value
appears.
 Press , the current setting will be displayed.
 To enter the lower limit, e. g. 1000 Kg, press the navigation
keys (See chap. 2.1.1); the currently enabled digit will be
flashing.
 Confirm input by
 Press repeatedly until
 Press , the current setting for the upper limit will be
displayed.
32
Goods to be weighed above tolerance limit
Goods to be weighed within tolerance range
Goods to be weighed below tolerance limit
at the same time in weighing mode.
.
is displayed.
Red signal lamp
glowing
Green signal lamp
glowing
Red signal lamp
glowing

SFB-BA-e-1630