Setting Your Heating System - Warmup 3iE Manuel D'installation Et De Programmation

sETTInG Your HEATInG sYsTEM

MASTER/RELAY
master
relay
n ok cancel
09:32
16
off
up down
24/7 Technical hotline - Ligne d'assistance technique - Línea de asistencia técnica
US 1.888.927.6333 / CAN 1.888.592.7687
Floor type
This setting will affect the upper and lower limits of
programmable set temperatures as well as the overheat limit.
If you set a user defined limit then you are advised to check
the safe temperature limits with the flooring manufacturer
Master/ relay
This feature allows you to use one thermostat to control
another. This is useful if you need to control multiple floor
heating elements with one program. In order to set-up this
feature use the following steps:
1. Choose which thermostat will be the "master" and
which will be the "relay".
2. Use low voltage electric cable to connect terminal 3 on
the "master" to terminal 3 on the "relay".
3. Use low voltage electric cable to connect terminal 2 on
the "master" to terminal 2 on the "relay".
4. In advanced settings of each thermostat switch the
"master" thermostat to master mode and the "relay"
thermostat to relay mode.
tues 23 jul 11
L On the "master" thermostat these connector cables
are in addition to the floor sensor but on the "relay"
thermostat the floor sensor is not necessary.
5. Program desired
thermostat. The "relay" thermostat will no longer use
its sensors for thermal regulation. It will now turn on/
off in tandem with the "master" thermostat.
schedule into the "master"