Warmup 3iE Manuel D'installation Et De Programmation page 11

EnErGY MonITor
If you want to view the estimated cost of your energy usage
then you will need to set the cost parameters in "energy
settings". The cost estimate will only be accurate for the time
period AFTER you set the heating costs.
• Single energy tariff means that you have a single cost
of electricity all day long
• Standard / low energy tariff means that you have a
discounted cost of electricity during part of the day.
Select the appropriate structure that applies to your
electricity tariff plan.
For both the standard and low energy tariff you will need
to set a cost per Kilowatt hour (KWH). First set the relevant
currency by pressing "up" and "down" (you can select £, $, €
and Y). Press "ok" to proceed to the first digit of the energy
tariff, press "up" and "down" to select the correct amount
and then press "ok" to proceed to the second digit. Continue
pressing "ok" until you have set all the digits and returned to
the ENERGY MONITOR main page.
L If your energy cost is 11.6 cents per KWH then you will
need to set it to $0.116.
If you are setting a "standard/ low energy tariff" you will also
need to set the time of day at which the low energy tariff
starts and stops and the cost per KWH during the low tariff
period.
After all these parameters are set you can view the cost of
the energy used by your floor heating system in "view cost
estimate". If you are using "standard / low energy tariff"
then the amount/ cost of energy used in the standard period
will be displayed in red and the amount/ cost used in the low
period will be displayed in white.
24/7 Technical hotline - Ligne d'assistance technique - Línea de asistencia técnica
US 1.888.927.6333 / CAN 1.888.592.7687
$
11