Installation Guide - Danby Designer DMW077BLSDD Guide D'utilisation Et Soins De Propriètaire

1) Make sure that all packing materials are removed from the inside of the microwave oven.
2) Check the microwave for any damage, such as misaligned or bent door, damaged door seals and sealing surface, broken
or loose door hinges and latches, and dents inside the cavity or on the door. If there is any damage, do not operate the
oven but contact a qualified service personnel.
3) This microwave oven must be placed on a flat, stable surface to hold its weight.
4) Do not place the microwave oven where heat, moisture, or high humidity are generated, or near
combustible materials.
5) For correct operation, the microwave oven must have sufficient air flow. Allow 20 cm of space above the microwave oven,
10 cm at back and 5 cm at both sides. Do not cover or block any openings on the appliance. Do not remove the feet on
which the microwave oven stands.
6) Do not operate the oven without glass tray, roller support, and shafts in their proper positions.
7) Make sure that the power supply cord is undamaged and does not run under the microwave oven or over any hot or sharp
surfaces.
8) The socket must be readily accessible so that it can be easily unplugged in an emergency.
SPECIAL CORD SET INSTRUCTIONS
DANGER:
Electric Shock Hazard: Touching some of the internal
components can cause serious personal injury or
death. Do not disassemble this appliance.

INSTALLATION GUIDE

6
WARNING:
Electric Shock Hazard: Improper grounding can result
in electric shock. Do not plug into an outlet until
appliance is properly installed and grounded.