Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Disassembly / Reassembly (to reassemble, follow procedures in reverse)
Part & No.
Screen Holder 5
Screen Holder
Gasket 4
Screen 3
8.1 Separating/Attaching Trap and Connector Bodies
1.
Loosen and remove the connector bolts, remove the entire trap unit from the connector body and
take it to a repair area where it can be supported in a vise during disassembly.
2.A When reinstalling the original trap:
a. Using a small screwdriver, remove the old gaskets from their housings in the trap body,
then clean the housings.
b. New connector gaskets must be installed.
c. To facilitate assembly and prevent loosening of the gaskets, apply a small amount of
suitable adhesive at 120˚ intervals around the outer edge of the gaskets.
d. Holding the trap body so that the gasket housings are horizontal, place the gaskets into
the housings.
2.B When installing a replacement trap:
a. Be sure to remove all protective seals, making sure the connector gaskets are still in place
after having removed their seal.
b. Before installation, scrape the mounting surface of the connector body clean using a soft
tool.
3.
Align the bottom edge of the trap body with that of the connector body (see Fig. A), making
sure the gasket housings on the trap body align with the corresponding recesses in the
connector body. Maintaining the proper alignment, close the tops together until the two
faces are flush, making sure that connector gaskets remain in position.
4.
Insert the connector bolts and finger-tighten, keeping trap and connector bodies flush.
Tighten the connector bolts to the proper torque (see page 7).
Fig. A
Trap unit P46UC is designed for use with TLV F46 and F32 connector units and TLV V1/V2/V1P/
V2P Series trap stations. This trap unit is not compatible with TLV F46J connector unit. The
connector unit name is indicated on the connector body.
Disassembly
Remove with a socket wrench Coat threads with anti-seize, then tighten
Remove gasket and clean
sealing surfaces
Remove without bending
Connector Body
to the proper torque (page 7)
Replace with a new gasket, coat surfaces
with anti-seize
Reinsert without bending
P46UC
̶ 11 ̶
Reassembly
Publicité
Table des Matières
