Switching The Appliance Off; After Grilling; Cleaning And Maintenance - Rommelsbacher BBQ 2012/E Gourmet Deluxe Mode D'emploi

Switching the appliance off

WARNING: Only if the residual heat indications of both grilling areas have extinguished, the
appliance may be disconnected from the mains!
• Disconnect the appliance from the mains by pulling the mains plug.

After grilling

• If the appliance has cooled down completely, remove the excess fat of the drip pan (for more
information, please refer to "Demounting the appliance").
• Clean the appliance after each use (for more information, please refer to "Cleaning and maintenance").

Cleaning and maintenance

NEVER IMMERSE BASE, CONTROL UNIT, MAINS PLUG AND
POWER CORD IN WATER!
Warning – hazard of injury and burns!
Before cleaning base, control unit, grill plate, splash guard/wind shield, drip pan or other
parts, let the complete appliance cool down!
• Always pull the mains plug before cleaning!
• Cleaning of the grill plate:
– Remove the grill plate of the grill.
– Remove coarse residues with the enclosed cleaning scraper.
– Afterwards, use a soft brush and some dishwashing detergent for cleaning and rinse with clear water.
– Soak stubborn residues on the grill plate with warm water with dishwashing detergent.
– Wipe dry thoroughly after cleaning.
• Cleaning base, control unit and power cord:
– Wipe base, heat protecting plate, control unit and power cord with a damp cloth.
– Afterwards, wipe dry thoroughly.
• Cleaning the remaining accessories:
– Clean splash guards/wind shield, drip pan etc. with a damp cloth and some dishwater.
– Afterwards wipe all parts dry thoroughly.
34
NOTE: Switching back to stand-by mode is acknowledged by an audible
signal and the red LED pilot lamp of the "ON/OFF" button blinks!
NOTE: The possibly running fan for cooling the control unit is still
in operation!
• The residual heat indications of the two grilling areas glow permanently.
• If a temperature blow 60 °C is reached, the indications extinguish.