Operation; High Pressure Hose And Spray Gun - Titan Tool Elite 3500 0537012 Mode D'emploi

operation

4
operATIoN
This equipment produces a fluid stream at
extremely high pressure. Read and understand
the warnings in the Safety Precautions section
at the front of this manual before operating this
equipment.
4.1

hIgh preSSure hoSe AND SprAy guN

1. Screw the high-pressure hose (2) to the coating material
outlet (Fig. 6, Item 1).
2. Screw the spray gun (3) with the selected tip onto the high
pressure hose.
3. Tighten the union nuts at the high-pressure hoses firmly
so that coating material does not leak.
4. Fully depress the pusher stem (Fig. 7, item 4) to make sure
the inlet ball is free.
4
12
5. Check the engine oil level daily before starting the sprayer.
The gasoline engine oil level is determined by the engine
manufacturer. Refer to the engine manufacturer's service
manual supplied with this sprayer.
6. Make sure the sprayer is grounded/earthed. All sprayers
are equipped with a earthing lug. An earthing cable (not
supplied) should be used to connect the sprayer to a true
earth ground. Check your local electrical regulations for
detailed earthing instructions.
7. Strain all paints with a nylon strainer to ensure trouble
free operation and freedom from frequent cleaning of the
suction filter and gun filter.
8. Make sure the spray area is well ventilated to prevent
hazardous operation with volatile solvents or exhaust
3
fumes.
1
2
9. Locate the sprayer outside the immediate spraying area to
avoid clogged air intake of the engine with overspray.
Proper grounding/earthing is important. The
passage of some materials through the nylon
fluid hose will build up a static electric charge,
which if discharged, could ignite solvent vapors
present and create an explosion.
If lacquer or other flammable materials are to be
sprayed, ALWAYS locate the sprayer outside the
immediate spraying area. Failure to do so may
cause an explosion.
Elite 3500